To Next PageTo Next Page
Need help?Do you have a question about the ICP PHX360000K00A1 and is the answer not in the manual?
General| Brand | ICP |
|---|---|
| Model Number | PHX360000K00A1 |
| Category | Heat Pump |
| Tonnage | 3 Ton |
| Cooling Capacity (BTU/h) | 36000 |
| Heating Capacity (BTU/h) | 36000 |
| SEER Rating | Up to 16 |
| Refrigerant Type | R-410A |
| Voltage (V) | 208/230 |
| Phase | 1 |
| Maximum Operating Ambient Temperature (°F) | 115 |
| Sound Rating (Outdoor Unit) (dB) | 76 |
| Unit Weight (Outdoor) (lb) | 220 |
Provides dimensional data and diagrams for the "B" chassis heat pump units.
Specifies the dimensions for roof curbs compatible with "B" chassis units.
Provides dimensional data and diagrams for the "C" chassis heat pump units.
Specifies the dimensions for roof curbs compatible with "C" chassis units.
Key points for safe installation and operation of the unit.
Overview of the PHX3 unit and its design for outdoor installation.
Identification of access panels on the unit for service.
Minimum clearances required around the unit for airflow and service.
Requirements for installing the unit on a ground-level platform.
Requirements for installing the unit on a rooftop structure.
Instructions and precautions for lifting and positioning the unit.
Steps to convert the unit for downflow air discharge.
Details on connecting and installing the condensate drain line.
Requirements for installing a field-supplied disconnect switch.
Instructions for ensuring a proper ground connection for safety.
Procedures for connecting the main power supply to the unit.
Guidance on connecting the thermostat and low voltage wiring.
Recommendations for sizing ductwork for optimal performance.
Requirements for insulating outdoor ductwork installations.
Best practices for connecting ductwork plenums to the unit.
Information on filter types, sizes, and installation requirements.
Table detailing blower speeds and corresponding airflow.
Diagram and explanation of blower motor speed tap connections.
Detailed steps for selecting blower speeds for heating and cooling.
Pre-start checks to ensure proper installation and readiness.
Describes the operational sequence for cooling mode.
Describes the operational sequence for heating mode.
Explanation of the compressor recycle delay timer.
How continuous fan operation is managed by the thermostat.
Details on how the unit operates in defrost mode.
Routine checks for air filters and condenser coil.
Monthly checks specific to the cooling season.
Cleaning and clearance requirements for the condenser coil.
Checking and cleaning the condensate drain.
Procedures for annual unit inspection and cleaning.
Maintenance for the condenser fan motor, noting lubrication.
How to access the blower motor for maintenance.
Inspection and cleaning of the circulating air blower.
Detailed instructions for safely rigging and lifting the unit.
Schematic diagram illustrating the unit's electrical connections.
