Need help?Do you have a question about the ICP OLB6-R097-130-5 and is the answer not in the manual?
General| Model | OLB6-R097-130-5 |
|---|---|
| Category | Furnace |
| Manufacturer | ICP |
| Efficiency | 80% AFUE |
| Input Capacity | 97, 000 BTU/hr |
| Fuel Type | Natural Gas/LP |
| Voltage | 115V |
| BTU | 97, 000 |
General safety guidelines for installing oil-fired heating units.
Critical requirements and warnings for safe furnace installation and operation.
Explains hazard signal words (Danger, Warning, Caution) used in manuals and on products.
Advises on preventing damage from freezing during cold weather when the unit is off.
Lists applicable codes and guides furnace placement for safety and accessibility.
Overview of general venting principles and methods for the furnace.
Specific instructions and warnings for venting the furnace through a chimney.
Guidance on selecting appropriate flue pipe sizes based on appliance input and chimney height.
Details on the DV-2000™ system for side-wall venting and its components.
Requirements for vent terminal location and installation clearances.
Step-by-step instructions for connecting the DV-2000™ venting system to the furnace.
Procedures for connecting the flexible vent to the vent terminal.
Steps for properly installing the vent terminal through the building wall.
Instructions for connecting the combustion air intake piping to the vent terminal.
Importance of adequate combustion air and factors affecting it.
Hazards and precautions when dealing with contaminated air sources.
Information on certified kits for providing outdoor air for chimney-vented furnaces.
Guidelines for using ducted outdoor air for combustion with specific burners.
How to verify correct electrical polarity for the burner control system.
Information on selecting and adjusting nozzles and air/turbulator settings.
Guidelines for installing humidifiers and air conditioning coils.
Proper installation of ductwork and air filters for optimal performance.
Description of manual switches for controlling furnace operation.
Step-by-step operational sequence for the Beckett AFII burner.
Step-by-step operational sequence for the Riello 40-BF burner.
Operational sequence for AFG and Riello 40-F burners with chimney venting.
Operational sequences for the DV-2000™ venting system, normal and abnormal.
Routine checks and adjustments required for furnace maintenance.
Procedure to follow if the burner stops unexpectedly.
Process for curing the ceramic combustion chamber before testing.
Steps for performing smoke and CO2 tests and adjusting burner air.
Method for testing and calculating the air temperature rise across the furnace.
Procedure for measuring and interpreting vent temperature readings.
Adjusting fan limit settings for proper furnace operation.
Testing the safety shutdown system for blocked intake or vent conditions.
Importance and overview of regular furnace inspection and maintenance.
To Next Page
