ICS MERIT M500 - Terminology

7
© 2024 ICS, Oregon Tool, Inc. Specications and pricing are subject to change without notice. REV07102024-p/n 646325
TERMINOLOGY
Arbor Shaft:
Where the blade mounts to the saw
Blade Depth Control:
Allows to set a predetermined depth before cutting
Blade Flange:
Secures the blade to the saw
Blade Guard:
Covers blade to protect hands and feet of operator and bystanders
Blade Nut:
Secures the blade flange to the saw
Display controller:
Saw display, displays the engine parameters.
Emergency Stop Button:
Located on front of saw, stops machinery quickly in case of emergency
Gearbox:
Rotates the blade at dierent speeds
Handlebars & T-locks:
Locks the handle bars in the four dierent angle positions depending on operator preference
Hydro-Static Pump:
Drives the rear saw wheels
Ignition Switch:
Turns the engine on and o
Lift Pump:
Lifts the blade out of the cut
Nightlight Switch:
Turns on the LED light for night cutting
Pointer Frame:
Used as a guide for a straight cut
PTO:
Transmits the engine rotational power to the gearbox via a set of belts
Raise & Lower Handle:
Raises and lowers the saw to allow blade to cut
Rear Access Panel:
Allows access to battery, fuel components and lift pump
Speed Control:
Regulates the speed and direction of the motor
T-Handle:
Controls the forward and reverse speed
Throttle:
Increases or decreases the engine speed
Traction control:
Reduces slipping of saw when engaged
Water Valve:
Controls water and flow to the blade