CUSTOMER SUPPORT: 800.321.1240 EMAIL: orders@icsdiamondtools.com
Rev 12.17.19
Problem Possibilities Solution (see “How to”) How to
Saw won’t start
Emergency stop engaged Disengage emergency stop Pull and twist to disengage.
Contact blocks damaged
Inspect contact blocks and
connections
Remove contact blocks from panel, inspect
for continuity.
Dead battery Have battery tested Use multimeter, or have tested.
Loose cables
Ensure clamps are clean and tight -
check power and ground on engine
connections
Inspect clamps and clean if necessary,
visually inspect power and ground
connections on the engine.
Bad starter Have starter electrically inspected Remove starter and have tested.
Bad ignition switch
Inspect using multimeter or replace
switch
Check for continuity and conectivity.
Replace if necessary.
ECU connections
Visually inspect pins for corrosion -
replace ECU if issue persists
Remove main plug - ensure all pins are
clean and seated (not bent or missing).
Low/no fuel Inspect fuel tank (not guage) for fuel
Remove fuel cap and visually inspect inside
of the fuel tank.
Fuel pump
Check voltage. Replace if voltage is
supplied and does not engage
Turn key on, fuel pump has audible sound.
Clogged/dirty fuel lter Inspect fuel lter / replace if neccesary Clean lter housing to visually inspect fuel ow.
To Next Page
Loading...
