Innovative Circuit Technology Ltd. 11
The alarm screens are displayed only if the alarm input has been enabled using
the Alarm Setup section of the web based graphic interface
Line 1: Alarm input number (1 to 5)
Line 2: Name of the alarm (if configured, default is blank)
Line 4: Alarm Status (ALARM if alarm is triggered, READY when not triggered)
Figure 4: LCD Display Screens
Status Indicators and Alarms
The channel LEDs (fuse version) and the Bus Alarm LEDs (breaker version) on the
front panel and the Form-C Bus Alarm contacts on the back are used to indicate
an alarm condition.
BUS A MENU BUS B MENU
BUS: "A" BUS: "B"
SYS VOLTAGE: 13.80V SYS VOLTAGE: -51.2V
BUS CURRENT: 76.4A BUS CURRENT: 32.5A
100 Base-T 100 Base-T
182.168.0.180 182.168.0.180
00:50:C2:02:10:2C 00:50:C2:02:10:2C
STATUS: ENABLED STATUS: ENABLED
VOLTAGE: 13.80V VOLTAGE: -51.2V
CURRENT: 14.5A CURRENT: 8.7A
STATUS: ENABLED STATUS: ENABLED
VOLTAGE: 13.80V VOLTAGE: -51.2V
CURRENT: 0.0A CURRENT: 0.0A
STATUS READY STATUS READY
STATUS ALARM STATUS ALARM
To Next Page
Loading...
