Innovative Circuit Technology Ltd. 29
o IP Address: 192.168.0.180
o Subnet Mask: 255.255.255.0
o Gateway: 192.168.0.1
If the HTTP port of the panel has been changed, you must append the
new port number to the URL used to access the panel. (See the Network
Setup section) See the Password Reset section for details on how to
reset the port number to the factory default value.
If your network switch allows you to manually configure port speed and
duplex settings, turn-on “Auto Negotiation” for the switch port that the
panel is connected to.
I forgot my password:
See the Password Reset section of the manual
I am not receiving e-mails from the panel:
Verify that the Send-E-mail checkboxes are ticked for any alarm
conditions for which you wish to receive e-mail notifications.
Verify your e-mail settings by going to the Maintenance page on the
panel’s web utility and clicking on the Send Test E-mail button, to send
a test message to your designated recipient addresses. The Send Test E-
mail page will show an error message if the panel is unable to send the
e-mail.
Check on the E-mail Setup page and ensure the SMTP Server field is the
correct address for your e-mail provider, and the SMTP Port is correct.
(Port should be 25 for most servers)
If your SMTP server requires SSL encryption, ensure the SMTP Server
requires SSL checkbox is ticked. Otherwise leave blank.
If your SMTP server requires authentication ensure that the SMTP User
Name and SMTP Password fields are correctly entered.
To Next Page
Loading...
