unsorted municipal waste and should be collected separately and disposed of according to your
national regulations. In the European Union, all equipment purchased from ID PHOTONICS can
be returned for disposal at the end of its useful life. ID PHOTONICS will ensure that all waste
equipment returned is reused, recycled, or disposed of in an environmentally friendly manner,
and in compliance with all applicable national and international waste legislation. It is the
responsibility of the equipment owner to return the equipment to ID PHOTONICS for appropriate
disposal. If the equipment was imported by a reseller whose name or logo is marked on the
equipment, then the owner should return the equipment directly to the reseller. If you have
questions concerning disposal of your equipment, contact ID PHOTONICS’s at WEEE@id-
photonics.com.
1.5 Line Voltage Selection
CoBrite Mainframes operate from any single-phase AC power source that supplies 100 ~
240VAC at a frequency at 50/60 Hz. The input line voltage setting is done automatically by
CoBrite power supply.
1.6 Service
Do not attempt to service or adjust this instrument unless an authorized person is present. Do
not install substitute parts or perform any unauthorized modifications to this instrument. Contact
ID Photonics or your local distributor to obtain service support.
1.7 Help and User feedback
ID Photonics GmbH is dedicated to continuously improve customer experience of our products.
Thus, if you have any feedback that might help us to improve our products send us an E-Mail to:
feedback@id-photonics.com
1.8 Optical output of Laser Ports
Each laser port features a polarization maintaining Fiber output which can be both used with
standard single mode fibers and polarization maintaining fibers. The emitted E-field is oriented
along the slow axis of the fiber.
1.9 Safety
1.9.1 General Safety Precautions
The following general safety precautions must be observed during all phases of operation of this
instrument. Failure to comply with these precautions or with specific warnings elsewhere in this
manual violates safety standards of design, manufacture, and intended use of the instrument.
ID Photonics assumes no liability for the customer’s failure to comply with these
requirements.
Before operation, review the instrument and manual for safety markings and instructions. You
must follow these to ensure safe operation and to maintain the instrument in safe condition.
To Next Page
Loading...
