1.9.12.6 Precautions with Connectors
It is essential to ensure that all optical connectors are in good condition. Dirty connectors can
lead to poor performance, while broken connectors can cause damage to other equipment!
Before an optical connector is used, check it visually by using an optical microscope as
recommended by the manufacturer of the connector. If the connector needs to be cleaned,
apply the cleaning procedure recommended by the manufacturer of the connector.
Make sure you are familiar with these issues to avoid damage to your device and possible
violation of warranty.
Important!
Before connecting the inputs or outputs to any measurement equipment or device under test,
make sure that a suitable attenuator, if necessary, is fitted.
2 Unit Overview – Operating principle and block diagram
2.1 CBDX
To Next Page
Loading...
