• Make sure that the option “CDM20802 driver” is selected
Note: If installing updates of the Software, do NOT select the
“CDM20802 driver” as it will install multiple instances of the driver.
• Follow instructions given by installer software. You may chose custom options
in the process.
• Now, supply power to the instrument. A red status LED should light up that
indicates power to the instrument
• Plug in the USB cable to the instrument and your computer
• Once plugged in, your computer should start automatically configuring drivers
for the instrument. Your computer will signal once installation is done
• Now start the Software under “Start – Programs – CoBrite
5.3 Start screen
After starting the GUI software the following screen will appear:
First, chose which interface is used to connect to the instrument by clicking on
“Ethernet”, “Mainframe description” or “USB Serial Port”. If USB is used, we
recommend using “Mainframe description”.
5.3.1 Ethernet
(Not applicable for CoBriteDX1 as this instrument provides no Ethernet port)
To Next Page
Loading...
