ID Photonics CoBrite Series - Uninstalling CoBrite Software

___________________________________________________________________
CoBrite
DX1
User Manual
42
Syntax and Type
Description
that always 0 is returned. An error will be returned
of the feature is not supported on your laser
Set: Enables or Disables the Sweep feature of a
laser port and defines parameters. If sweep is
disabled, the other parameters are ignored.
See details for parameter range in general section
of this manual.
Set example:
sweep 1,1,1,60,5000,5000,1;
Enables a 60GHz sweep with a rate of 5GHz/s and
a trigger interval of 5GHz (=1Hz repetition rate).
Read Example:
sweep? 1,1,1;
Returns
60,0,5000,1;
7.7 Error code definition
Error
code
Description
1
Execution error
4
Timeout communication to laser
5
Command was sent to laser several times but not accepted
6
Command transmission error
100
Command error
101
Syntax error
102
Illegal Parameter error
103
Too much data, buffer overflow
104
Device not ready
105
Command execution error
106
Limit exceeded
110
No valid Port
8 Uninstalling CoBrite Software
Software may be uninstalled by either using the well-known central Windows built-in
“Add/remove Programs” function or by running “setup.exe” from installation medium
again.