5.7 Slot view
Slot view is accessed by clicking on any slot of the left hand side tree view.
Click on any port to access parameters of laser ports located on that card which are
represented in the left hand side of the GUI. Refer to section 5.5 on features
available by this table.
5.7.1 ITLA temps & currents
This view allows reading the current Laser chip and Base temperature of each laser
as well as current laser diode current and TEC current.
5.7.2 Limits
This section displays the minimum and maximum values that can be adjusted to the
according laser port.
5.8 Communication logging window
This window can be opened from the system view and allows tracing the
communication between the GUI software and the chassis controller.
To Next Page
Loading...
