iDataLink maestro SW User Manual

15
[Z]
>>
_________________________________
16
>>
17
>>
_________________________________
18
>>
>>
19
20
OFF
ACC ON
START
21
OFF
ACC ON
START
22
OFF
ACC ON
START
23
OFF
ACC ON
START
24
>>
LED will fl ash GREEN [Z] times to match the
function [Z].
EXAMPLE: If LED fl ashes 3 times, the cor-
responding function is 3.
Choose a steering wheel button to pair with its
corresponding function.
EXAMPLE: The steering wheel “Volume Up”
button must be paired with the “Volume Up”
function.
Press and hold that steering wheel button un-
til LED turns solid GREEN to pair the function.
NOTE: Press programming button once [1x] to
skip a function.
Repeat steps 16 and 17 for every other
steering wheel button and its corresponding
function.
NOTE: LED will fl ash RED once [1x] for func-
tion 10.
NOTE: LED will fl ash RED once [1x] then will
fl ash GREEN once [1x] for function 11.
Press and hold programming button until
LED turns solid GREEN. LED will remain solid
green.
Turn key to OFF position.
Remove key. LED will turn OFF.
Insert key into ignition.
Turn key to ON position. LED will remain OFF.
Function pairing procedure completed.
NOTE: Test every steering wheel button, one
by one, to verify aftermarket radio control.
fuNCTION PaIRINg PROCEDuRE - 2 Of 2
www.maestro.idatalink.comAutomotive Data Solutions Inc. © 2012
ADS-SW(SI)-ALL01-AS-IG-EN
PagE 7 Of 8
• 20120913
DOC.: #9729

iDataLink maestro SW Specifications

General

Brand	iDataLink
Model	maestro SW
Category	Control Unit
Language	English