What to do if the circuit breaker goes off with my Ideal Clima KERS 50 Heater?
If the circuit breaker goes off when using your Ideal Clima Heater, it's likely due to a short circuit causing an overload. To address this, turn off the unit immediately and contact a service center for assistance.
Why Ideal Clima Heater does not start?
If your Ideal Clima Heater isn't starting, the issue could be due to a lack of power supply to the unit. Verify that power is reaching the power terminals. Alternatively, the motor might be blocked, or the impeller clogged. In this case, turn off the heater, resolve the motor jam, clean the propellers, and then restart the unit.
What to do if Ideal Clima KERS 50 has insufficient air flow?
If you're experiencing insufficient airflow from your Ideal Clima Heater, it might be set to a speed that's too low; try choosing a higher speed level. Another potential cause is a dirty filter, fan, or heat exchanger. Clean or replace the filters and clean the fan and heat recovery components.
Manufacturer's disclaimer regarding accidents due to non-compliance with manual instructions.
Rules for safe and optimal unit operation, including reference to directives and safety regulations.
Highlights the importance of experience, qualified personnel, and preventive maintenance for unit longevity.
Describes the unit's function for room-by-room heat recovery in wall installations.
Mandates personal protective equipment (PPE) and availability of safety equipment like fire extinguishers.
Details unit components, filters, and operating modes: Extract, Supply, and Heat Recovery.
Specifies the recommended ambient temperature and humidity ranges for unit operation.
Describes the electrical board construction and EC motor specifications.
Illustrates connection methods for single units and series connections of multiple units.
Details the location and capacitive function of the unit's control switches.
Describes the buttons and functionalities of the remote control unit.
Covers configuration options via dip switches for modes like speed and humidity control.
Provides instructions on how to seal the unit to prevent drafts during inactivity.
Lists key technical specifications including airflow, noise levels, power consumption, and protection ratings.
Details energy consumption, efficiency, and other data relevant to energy labeling standards.
Provides the physical dimensions and outline drawings of the KERS 50 unit.
A table outlining common failures, their causes, and recommended solutions.
Step-by-step instructions for cleaning filters, heat exchangers, and other maintenance tasks.
Guidelines for the proper end-of-life disposal and recycling of the unit's components.
Details pre-installation checks for unit integrity and safe handling.
Clarifies that KERS models are designed exclusively for indoor installation.
Provides a detailed breakdown of all unit components with their names.
Instructions for preparing the wall, drilling, and inserting the telescopic duct for mounting.
Guides the user through the initial power-up procedure after installation.
General| Brand | Ideal Clima |
|---|---|
| Model | KERS 50 |
| Category | Heater |
| Language | English |
To Next Page
