To Next PageTo Next Page
Need help?Do you have a question about the IDEAL 2603/2 SM/C and is the answer not in the manual?
General| Brand | IDEAL |
|---|---|
| Model | 2603/2 SM/C |
| Category | Paper Shredder |
| Language | English |
Read and follow all safety precautions before operating the machine.
Ensure the operating instructions are always kept readily accessible.
Children must not operate the machine.
Do not reach into the feed-opening of the cutting head.
Long hair can become entangled in the cutting head.
Take care of ties and other loose pieces of clothing.
Be careful of loose jewellery as it can get caught in the mechanism.
The document shredder must be operated with the door closed.
Ensure free access to the mains power connection.
Remove the plug before cleaning the machine.
Do not perform any repairs on the document shredder yourself.
Do not operate the machine without the safety flap.
Using the ON/OFF switch for stopping and opening the door.
Attach the oiler holder to the side of the cabinet.
Connect the oil tube to the oiler and screw it on.
Close the door and plug the machine into the wall socket.
The oil pump starts automatically on first use.
Press the switch until the red LED stops blinking.
Indicates automatic oiling and oil bottle status.
Press the switch to turn the machine on and off.
Display indicates used sheet capacity during shredding.
Indicates automatic stop due to too much paper or jam.
Shows maximum sheet capacity during shredding.
Indicates normal sheet capacity during shredding.
Machine stops automatically when no paper is fed.
Machine stops automatically if the door is opened.
Machine stops when the collection bag is full.
Machine stops and reverses if too much paper is inserted.
Press 'R' to reverse and remove jammed paper.
Press the reset switch and re-feed paper in smaller quantities.
Machine stops automatically if the safety flap is opened.
Ensure the machine is properly plugged into the power outlet.
Check if the rocker switch is pressed and the green light is on.
Ensure paper is inserted correctly into the feed slot.
Feed paper into the center of the feed opening.
Ensure the door is closed and the collection bag is not full.
The machine will not operate if the safety flap is open.
If indicator lights but bag is not full, remove paper debris.
Remove paper debris between the cutting head and flap with a brush.
Clean the photo cell with a small brush if the machine does not stop.
Machine stops due to overload; allow 10-15 minutes for cooling.
Contact service if problems persist after troubleshooting.
Environmentally friendly oil for machine maintenance.
Plastic bags for collecting shredded paper.
Do not shred paper clips, CDs, or DVDs.
Machine approved by safety laboratories and compliant with EC directives.
Sound level is less than 70 db (A) as per ISO 7779.
Declares compliance with relevant EC directives and harmonized standards.
