IDEAL 4305

- 10 -
•
Operation
• •
ماﺪﺨﺘﺳﻹا
Example: Cutting measurement 208,50 mm
The measurement is set with the
backgauge crank (F). Proceed to
position from the rear. Measurement is
indicated on the back side lay (H) (mm/inch).
The fi ne adjustment is achieved by using the
calibration ring (I).
The scale is divided in mm (One complete
turn corresponds 10 mm = 1 cm).
See example cutting measurement
208,50 mm.
ϝΎΜϣ : Γ΍
Ω΃αΎϘϤΑ ϊτϘϟ΍ αΎϴϗ 208.50Ϣϣ
Ϧϴϴό
Η ϢΘϳαΎϴϘϟ΍ Γ΍Ω΃ϖϓήϤϟ΍ ήΒϋ
ΰΟΎ
Τϟ΍ )F .( ϢΘϳ ϪϴΟϮΗαΎϴϘϟ΍ Γ΍Ω΃
ĸ ϒϠΨϟ΍ Ϧϣ.
νήϋ ϢΘϳαΎϴϘϟ΍ Γ΍Ω΃ ϰϠϋ
ϲΒ
ϧΎΠϟ΍ ΰΟΎΤϟ΍ Ϧϣ ΔϴϔϠΨϟ΍ ΔϬΠϟ΍)H) .(Ϣϣ/ΔλϮΑ.(
Ύϣ΃ΔΌϴϬΘϟ΍ϝϼΧ Ϧϣ ϢΘΘϓ ΔϘϴϗΪϟ΍
αΎϴϘϤϟ΍ ΔϘϠΣ)I .(
αΎ
ϴϘϤϟ΍ ϦϴϴόΗ ϢΘϳ
Ϣϣ ΔΌϔΑ) . ϝΩΎόΗ ΓΪΣ
΍ϭ Δϔϟ10 Ϣϣ =1Ϣγ .(
ϝΎΜ
ϣ ήψϧ΍ϊτϘϟ΍ αΎϴϗ Γ΍Ω΃αΎϘϤΑ 208.50Ϣϣ .
