Protect mains cable against heat, oil and
sharp edges!
•
Safety precautions •
Standard machines are factory-set as follows:
•
Power supply:
400 V, 3P+N+PE
220 V, 3P+PE
•
Frequency 50 / 60 Hz.
Machine does not function
• Is the machine E switched on?
• Is the key-switch
D on.
• Is the green overload switch
a pressed?
• Is the black overload switch
b pressed?
• Check on-site fuse.
If the machine still does not function then the
rotation must be reversed.
The machine is wired according to the IEC
standards. We recommend that alterations to
the rotary direction be made in the socket.
It is also possible to make alterations in the
plug by exchanging "L1" and "L2".
Danger!
Incorrect exchanging of the connections
will endanger the operator.
This work must be carried out by an
electrician.
To Next Page
Loading...
