Why does my IDEAL Paper Cutters object peel off the build plate during printing?
Inconsistent plate height can cause adhesion issues, so start by releveling your build plate. Also, ensure the build plate is clean, wiping away any dust or oil with a lint-free cloth. If the problem persists, you might need to replace your Grip Surface.
What to do if printed object is stuck to the build plate of IDEAL Paper Cutters?
Carefully use a thin metal craft spatula to work the blade under the stuck object. Once the blade is mostly underneath, twist the handle slightly to free the object. Avoid using knives or sharp tools to prevent damage to the build plate and potential injury.
Why print files don’t appear in USB storage for IDEAL Paper Cutters?
Ensure that your print files are in the correct format with a '.makerbot' file extension. Also, the USB drive must be formatted to FAT32, as drives formatted to NTFS will not be visible.
Why the plate leveling routine does not result in a level build plate for IDEAL Paper Cutters?
The assisted leveling routine depends on a clean, flat plate and a clean extruder nozzle. Plastic debris on the build plate or nozzle can interfere with the extruder sensor.
Why filament breaks between the spool and the Smart Extruder+ in IDEAL Paper Cutters?
Check that the filament unwinds counterclockwise from the spool. Ensure the filament guide tube is not twisted or bent. Remember to unload any remaining filament from the Smart Extruder+ before reloading.
What to do if I can’t remove filament from the Smart Extruder+ of IDEAL Paper Cutters?
Try running the filament load script and allow the plastic to extrude for a few seconds. Then, attempt the unloading process again.
What to do if filament won’t extrude from the Smart Extruder+ of IDEAL Paper Cutters?
Try unloading and reloading the filament.
What to do if the Smart Extruder+ is installed, but the MakerBot Replicator+ does not recognize it in IDEAL Paper Cutters?
Remove the Smart Extruder+ and run the extruder attachment script by navigating to Extruder > Attach Smart Extruder Now.
Why screen does not respond to touch on IDEAL Paper Cutters?
The control panel screen is not a touchscreen. Use the dial to scroll through options and press the dial to select.
Prevent children from operating and keep hands clear of the blade.
Never leave the blade unattended or transport without protection.
Operate machine only with covers, safety beam guard, and two-hand control.
Check power connection, main switch, control activation, and fuses.
Check safety light beam, measurement reach, and false clamp plate status.
Formal declaration that the machine complies with relevant EC directives and harmonized standards.
General| Cutting Length | 720 mm |
|---|---|
| Cutting Capacity | 80 mm |
| Weight | 261 kg |
| Cutting Height | 80 mm |
| Warranty | 1 year |
To Next Page
