• Possible malfuntions •
Cut cannot be activated.
•
Safety light beam is interrupted /dirty.
Remove all items obstructing the safety
area (A) and clean the glass from the
sender (B) and receiver (B).
•
Measurement has not been reached
correctly.
Push the
S button again.
• Measurement below 9 cm.
The false clamp plate must not be mounted.
Remove the false clamp plate and store it
in the provided holder (see page 18).
The machine does not funktion after being
moved to another position.
If the machine still does not function then the
rotation must be reversed.
The machine is wired according to the IEC
standards. We recommend that alterations to
the rotary direction be made in the socket.
It is also possible to make alterations in the
plug by exchanging "L1" and "L2".
Danger!
Incorrect exchanging of the connections
will endanger the operator.
This work must be carried out by an
electrician.
To Next Page
Loading...
