To Next PageTo Next Page
Need help?Do you have a question about the IDEAL 5255 and is the answer not in the manual?
General| Brand | IDEAL |
|---|---|
| Model | 5255 |
| Category | Paper Cutters |
| Language | English |
Read instructions, observe precautions, and heed warnings about children and blade access.
Never leave blade unattended, ensure protection during transport, avoid injury, and don't cut splintering materials.
Follow one-man operation, avoid blade damage, disconnect power for maintenance, and replace blade with switch off.
Cutting movement is safeguarded; perform pre-operation checks on guards and controls.
Ensure all hazardous components are guarded and safety devices are operational before use.
Protect mains cable; ensure blade is always covered by the pressing bar.
Assemble stand, lift machine, secure with screws, and place shelf.
Understand instructions, check safety devices, ensure covers are mounted, and use two-hand control.
Set main switch, insert key, open guard, and press Start button.
Clamp activates automatically during cutting; actuators control pre-clamping and cutting.
Press both actuators simultaneously and hold until the cut is complete.
Release actuators to stop or interrupt the cutting process.
Identifies and describes key operating elements like safety systems, switches, and displays.
Initiate machine operation and adjust changeable functions like brightness and language.
Select MANUAL, enter dimension, press START, position paper, close guard, and release cut.
Follow sequence: activate cut, set dimension, position paper, close guard, release cut.
Enter number of cuts and size; START advances backgauge for each subsequent cut.
Run program 08: enter number, START, insert paper, release cuts, and advance to next step.
Follow steps to execute program 08, including paper handling and multiple cut activation.
Danger! Blade is extremely sharp; use trained staff, protection, and proper tools.
Remove cutting stick with screwdriver; turn or exchange it as needed (usable 8 times).
Turn blade adjusting screw left, remove stick, turn non-used side to blade, and plug into bolt.
Cut paper; adjust blade depth adjustment screw (A) if sheets are not fully cut.
Danger! Blade must always be covered by the pressing bar.
Maintenance by trained staff only; disconnect power before any service or cover removal.
Check power connection, main switch, control activation, and safety interlocks.
Ensure safety cover is closed; if closed, open and re-close it for a security check.
Check for overload, safety button ejection, blocked backgauge, or blunt blade.
Turn cutting stick or adjust blade knob if last sheet is not cut through.
Security brake may be active; contact service if problem persists after checks.
