Take out the cutting stick with a small screw-
driver. If needed the cutting stick can be
turned or exchanged. (The cutting stick can
be used eight times).
Replacing the cutting stick (not the blade)
•
Turn the blade depth adjustment (A) towards
the top until the blade screw recess
corresponds with the frame recess.
See page 29. (Otherwise the rst cut will be
too deep).
•
Remove spanner
•
Remove the cutting stick according to top
picture.
•
Turn the cutting stick (the non-used side
must be near to the blade) and plug it into
the left holding bolt.
Danger! Risk of injury!
Cutting test after replacing the cutting
stick (not the blade)
•
Insert the paper and release the cut.
•
If the last sheet of paper is not cut along the
entire length turn the blade depth adjusting
screw (A) 1/12 downwards using a spanner.
•
If the last sheet is still not completely cut
repeat this process until the last sheet is cut
along the entire length.
•
Blade and cutting stick replacement •
To Next Page
Loading...
