Appearance and Components
Packing List
Note: The packing materials are actually based on the order.
Xiamen Hanin Electronic Technology Co., Ltd.
ADD: 4F, 2#, Aide Airport Industrial Park, Huli District, Xiamen, China.
WEBwww.idprt.com
iT4B
Quick Start Guide
Printer AC Adapter Power Cord Label Roll Ribbon Spindles
Ribbon
Note: The packing materials are actually based on the order.
USB Cable
Empty Ribbon Core
CD
Quick Start Guide
Quick Start Guide
Front View
Front Cover
Power Buon
Printer Cover
Status Indicator
Feed Buon
Cover Open Buons
Rear View
USB Port
(Type B)
Ethernet Port
Power Receptacle
Moveable Roll Holders
Locking Tab
Inside View
Printer Mechanism
Mechanism Lock
Back Label Sensor
Front Label Sensor
Platen
Moveable Label Guides
FCC WARNING：
This device complies with part 15 of the FCC Rules.
peraon is subect to the followin two condions
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
includin interference that may cause unde
sired operaon.
Any chanes or modicaons not epressly approved
by the party responsible for compliance could void the
user's authority to operate the equipment.
TE This equipment has been tested and found to
comply with the limits for a Class A diital device,
pursuant to part 15 of the FCC Rules. These limits are
desined to provide reasonable protecon aainst
harmful interference when the equipment isoperated
in a commercial environment. This equipment
enerates, uses, and canradiate radio frequency
enery and, if not installed and used in accordance
with the instrucon manual, may cause harmful
interference to radio communicaons. peraonof
this equipment in a residenal area is likely to cause
harmful interference in whichcase the user will be
required to correct the interference at his own
epense.
-- Reorient or relocate the receivin antenna.
-- ncrease the separaon between the equipment and
receiver.
-- Connect the equipment into an outlet on a circuit
dierent from that to which the receiver is connected.
-- Consult the dealer or an eperienced radioT tech
nician for help.
To maintain compliance with FCCs RF Eposure
uidelines, This equipment should be installed and
operated with minimum distance between 20cm the
radiator your body Use only the supplied antenna.
Cauon:
This is a Class A product. In a domesc environment this
product may cause radio interference in which the user
may be required to take adequate measures.
To Next Page
Need help?
General
