iDPRT iX4P - Loading Printer Supplies; Loading the Ribbon; Loading the Paper; Connecting the Power

-4-
-4-
Loading the Roll
Loading the Ribbon
Rev.1.0
1. 
cover 
by hands.
3. Pull a part of ribbon, then pass the ribon
between the print mechanism
and the
media sensor.
4. Pass the ribbon over the print mechanism
and the ribbon take-up spindle, and then
wrap it serveral turns around the ribbon
take-up spindle.
！
Note: Please refer to windows driver installa�on in iX4 Series User Manual.
1
2
Varies by regions
2.Connect the other end of power cord to the AC
power port.
1.Connect the power plug to power receptacle.
Power Cord
Loading the Ribbon

Clockwise
2. Load the out side ink ribbon into ribbon
supply spindle, 

-6-
-5-
2. Mount a label roll onto the media spindle. Be sure to push the roll all the way aligned
the inner wall of the printer. guide back on
the media spindle. Then rotate lock

3. 
it reaches  apart to adjust for the label
width.
Loading the Paper
5.the print head lever to make ribbon and label 
snugly.
1. Rotate the arrow mark that locates in media guide lock of media spindle to unlocking
, then remove the media guide.
4. When using the gap label, black mark label or punch hole label, you can manually adjust

.
Media Sensor 
Connec�ng the Power
Loading the Paper


Ribbon
Print mechanism
Media Sensor
Ribbon Take-up Spindle