Page 9 / 11
Rev.: 1105 / VP
7. According to the labels in the rear cover of the system, make de tubing
connections. For optimal system performance, it is recommend using tubing
lengths that are as short as possible.
8. Finish the installation, and after water and power on:
a. Turn on the tap water dispenser and keep and the water draining away
over 10 minutes (The flow is slowly) (And it is normally if drain black
water away)
b. Turn off the tap and turn on the tank valve, and start purifying water. It
takes about one or two hours for first time purifying, and water tank will
be filled (feeding and draining off will be automatically). The storage tank
has a capacity of 4-8 litres depending on the model.
c. Please, never drink the first purified water and remove it. To remove it:
turn on the tap water dispenser till a osmotic pure water doesn’t come
out (tank without water).
Suggestion:
Please, do as the steps under if you don’t use it one week or more days:
1. Turn off feeding switch
2. Remove the plug of power (Systems with pump)
3. Turn on the switch of feeding after coming back, then, insert the plug of power,
and turn on the faucet, after the water in the water tank draining away, then the
purifier will start purifying the water, and the water can be drank (Please,
change the filters if the purifier didn’t use so long).
: The reverse osmosis membranes contain a food-grade
preservative for storage and shipment. New membranes should
be flush removes the preservative. The preservative is not
harmful but makes the product water taste objectionable.
To Next Page