IDROBASE AURORA - Safety

29
• The integrity and insulation of the electric cable and equipment MUST BE checked, be-
cause the work environment is necessarily exposed to water and humidity conditions
that preclude the natural system insulation;
• DO NOT pull the cord to remove the plug;
• DO NOT touch the plug with wet hands or feet!
• Avoid accidental operation. You MUST place the switch OFF before inserting or removing
the plug from the socket;
• DO NOT use the machine if the cable is damaged or worn; disconnect the device from the
network and contact an authorized service center;
• In dangerous situations, the machine should be stopped immediately.
• DO NOT install the machine near ammable materials (expecially on environments with
airborne particles: plastics, resins, acids, inks, etc.);
• DO NOT use paints, acids, solvents, oily or very dense liquids, and so on;
• The machine MUST BE used by a properly trained single operator;
• DO NOT remove or tamper with the safety devices and protection installed on the ma-
chine;
• DO NOT use the machine in the presence of unauthorized person or persons who are not
wearing suitable protective garments;
• It is RECOMMENDED not to place the machine on ramps or sloped oor, possibly remem-
ber to lock the wheels with the appropriate mechanisms;
• ARE OBLIGED to place the machine on a at and level for both installation and storage;
• During the handling of the machine on sloping surfaces, potholes or on particularly un-
stable ground there is a risk that the machine chutes. The movement of the machine
under the circumstances described above MAY RESULT in malfunction due to sudden
impact or overturning;
• If the machine will be put outside good precautions must be taken in order to PREVENT
the dangerous effect of weather conditions.
• KEEP the machine clean and tidy;
• Absolutely NO MOVE the machine during operation;
• Absolutely NO MOVE the machine when connected to mains water and electricity
• The table (see par. 3.2) MUST BE used to place objects to a total load under 5 kg. DO NOT
sit or rest
2.7 SYMBOLS
In this manual the symbols depicted describe important functions of the machine for the
installation, and for the use and disposal. For correct and safe use of the machine the ope-
rator must read carefully all parts of this manual paying special attention to the warning
symbols and manufacturer’s plate.
PAY ATTENTION TO SAFETY IN THE WORKPLACE!
FOLLOW THE INSTRUCTIONS DISPLAYED ON THE WARNING SIGNS. FAILURE TO DO SO MAY
CAUSE SEVERE INJURY OR ENDANGER PERSONAL SAFETY. ENSURE THAT THE SIGNS ARE
PRESENT AND LEGIBLE. IF THEY ARE NOT, THEY SHOULD BE FITTED OR REPLACED.
THIS MANUAL MUST BE READ BEFORE USING OR CARRYING OUT MAINTENANCE OR OTHER
OPERATIONS ON THE MACHINE. DO NOT ALLOW UNAUTHORIZED PERSONNEL TO USE THE
MACHINE.
2  APPLICATIONS
GB
Copyright ©2017 Idrobase Group. All rights reserved.