EasyManua.ls Logo

IDS GeoRadar STREAM DP - Hazard of Use

IDS GeoRadar STREAM DP
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3 SAFETY DIRECTIONS Mod: MDM/011/M2 Rev 8
IDS GeoRadar Srl MNG/2022/007 Rev. 1.0 12/ 36
3.6 Hazard of use
WARNING: CRUSHING HANDS AND FINGERS
While installing the system, the risk of fingers pinch-out, may
occur.
PRECAUTION: To mount the system, the user must always
wear protective gloves and safety boots.
WARNING: RISK OF ACCIDENTS
During surveys there is a danger of accidents occurring if the
user does not pay attention to the surrounding site conditions,
such as obstacles, excavations or traffic.
PRECAUTIONS: During operations, the user of the product
must be fully aware of the existing site conditions.
WARNING: ELECTROCUTION
Because of the risk of electrocution, it is dangerous to use
poles and extensions near electrical installations such as
power cables or electrical railways.
PRECAUTIONS: Keep at a safe distance from electrical
installations. If it is essential to work in this environment, first
contact the safety authorities responsible for the electrical
installations and follow their safety instructions.
WARNING:
If the product is used with accessories (for example GNSS pole
support), the user may increase the risk of being struck by
lightning.
PRECAUTIONS: Do not use the product in a thunderstorm.
WARNING: SECURING OF THE WORKING SITE
Inadequate securing of the working site can lead to dangerous
situations, for example in traffic, on building sites, and at
industrial installations.
PRECAUTIONS: Always ensure that the working site is
adequately secured. Adhere to the regulations governing
safety, accident prevention, and road traffic.
NOTICE: If the accessories used with the product are not
properly secured and the product is subjected to mechanical
shock, for example blows or falling, the product may be
damaged.
Precautions:
When setting-up the product, make sure that the accessories
are correctly adapted, fitted, secured, and locked in position.
Avoid subjecting the product to mechanical stress