To Stay Arm
+ [USER CODE]
(Do not leave premises)
1. Select the required STAY PROFILE. (To Select a Stay profile page 10.)
2. Ensure that the READY icon is on; if not, check that all protected doors and
windows are closed and that motion has ceased in the areas covered by motion
detectors.
3. If necessary, close the front door.
4. Press the [#] key to cancel any unintended entries.
5. Enter a valid [USER CODE].
6. The ARMED icon will come on and the keypad buzzer will beep for the duration of
the exit delay.
7. DO NOT open the front door. If the front door is opened, the system will arm in
AWAY mode.
8. Any STAY zones (shown by a steadily lit indicator) will be automatically bypassed.
9. Ensure that you enter only those zones that are bypassed.
Quick Stay Arming
Hold down the key until the beep
It is possible to STAY arm by holding down the [5] key until the keypad beeps. There is no
exit delay.
Stay Arm and Go
Hold down the key until the beep
This is a quick function that allows the user to STAY arm and leave the premises.
1. Hold down the [6] key until the keypad buzzer sounds. The keypad buzzer will now
beep for the duration of the exit delay
2. At the end of the exit delay, the ARMED indicator will come on and the AWAY
indicator will remain off. Any stay zones will be bypassed.
3. Be sure to leave only via the Follower and Entry/Exit zones.
To Next Page
Loading...
Need help?
General
