Problems when Arming the System
Keypad beeps 3 times when entering a user code?
If you enter the wrong user code, the keypad will beep three times and the system will
not arm.
Is the READY Indicator on?
If this indicator is not on, one or more zones are violated. A flashing zone indicator shows
a violation. Ensure that all monitored doors and windows are closed. Bypassing a
violated zone will also create a READY condition.
Does the siren sound before you exit?
The exit delay may be too short - ask your installer to adjust the exit delay.
OR
You have not left via a Follower and Entry/Exit zone or have strayed into an Instant zone.
Either avoid these zones or ask your installer to change the zone type.
Problems when Disarming the System
Does the siren sound immediately upon entry?
You have not entered via the Entry/Exit zone or have strayed into an Instant zone.
Does the siren sound before you get to the keypad?
You have strayed into a non-follower zone.
OR
You have taken too long to get to the keypad.
The panel will not disarm.
You may have entered an incorrect code.
Press the [#] key first, then re-enter your user code.
To Next Page
Loading...
Need help?
General
