IDS Optex Xwave - 7.2. Detection Area

Pulse Count is the amount of times the detector needs to be triggered within a 20
second period before an alarm condition is sent.
When the 862-01-CX-702RSC detector is in Normal Operation it will only send an alarm
after a wait period of 120 seconds from the last alarm condition.
PIR Lens
Tamper Switch
Walk Test Jumper
On – Enables Walk Test (LED is
enabled, Pulse Count set to 1)
Off – Normal Operation
Pulse Count Jumper
On – Sets Pulse Count to 2
Off – Sets Pulse Count to 4
PIR LED
Enabled in Walk Test Mode,
Disabled in Normal Mode
Supervision Jumper
J1 On – 90 mins
J1 Off – 12 hrs
IDS Wireless
Transmitter
Power Connector
Connect the battery
holder lead here.
Detector Inputs
Tamper & PIR inputs
come from the
detector.