IDTECK ILAN422 User Manual

Model
ILAN422/485
Manual Connection Guide
1
1. Connection via RS422 (for ILAN422 converter)
a. DIP Switch Setting
For RS422 communication, you should set the DIP switch to the 422
position as shown in the picture below.
b. Connection Table
2. Connection via RS485 (for ILAN485 converter)
a. Dip Switch Setting
For RS485 communication, you should set the DIP switch to the 485
position as shown in the picture below.
Star 505R / FINGER007 ILAN422 Converter
RX+ (Brown Wire) T+
RX- (Blue Wire) T-
TX+ (Gray Wire) R+
TX- (Yellow Wire) R-
iCON100 / iTDC ILAN422 Converter
RX+ T+
RX- T-
TX+ R+
TX- R-
The operating voltage may vary depending on the
country. Check the voltage of your power adapter.
Note

IDTECK ILAN422 Specifications

General

Brand	IDTECK
Model	ILAN422
Category	Media Converter
Language	English

Summary

RS422 Connection Guide

RS422 DIP Switch Setting

Set the DIP switch to the 422 position for RS422 communication.

RS422 Connection Table

Wiring details for connecting RS422 devices like Star 505R/FINGER007 and ICON100/ITDC.

RS485 Connection Guide

RS485 DIP Switch Setting

Set the DIP switch to the 485 position for RS485 communication.

RS485 Connection Table

Wiring details for connecting RS485 devices like Star 505R/FINGER007, ICON100/ITDC, and RFL200C.

RS232 Connection Guide

RS232 DIP Switch Setup

Set the DIP switch to the 232 position for RS232 communication.

RS232 Connection Table

Wiring details for connecting RS232 devices like Star 505R/FINGER007 and ICON100/ITDC.

Quick Setup Guide

Converter Connection Methods

Methods for connecting the converter directly to a computer or via a HUB.

Converter Configuration Steps

Steps to install and run IPSearch.exe for converter configuration and IP settings.

Web Configuration Fields

IP Address Type Selection

Choosing IP address types: Static, Dynamic Client, or PPPoE. Static IP is recommended.

IP Address Configuration

Setting Converter IP, Subnet Mask, Gateway, and Primary DNS.

Serial Port Mode Configuration

Configuring Serial Type (RS232, RS485, RS422) and Baud Rate.

Operation Mode Settings

Selecting Operation Mode (TCP SERVER) and Connect Port Number.