Programming Occupied & Unoccupied Periods
Press
Select Occupied 1 to
run on this day (On),
or not to run this day
(Off).
Off
On
Selecting Yes, then pressing mode
will copy the previous day’s program
and then will ask the same copy
question again. If yes is selected
each time, this routine will repeat
until Saturday is copied to Sunday.
After Saturday is copied to Sunday,
the copy command is unavailable.
If no is selected, as in previous steps flashing prompts for
input will appear for start and stop times for Occupied 1.
If more than one occupied period was selected on page
13, then cool/heat setpoints, and start/stop times for
additional occupied periods will be prompted.
Select Yes or No to
copy the previous
day’s program to this
day.
Yes
No
Press
MODE
MODE
Press
MODE
Page 16
occupied
Tu
1
Co
Py
We
ON
occupied
Pm
Stop
Tu
1
5:00
Adjust the stop time
for occupied 1.
If No is
selected:
If Yes is selected:
To Next Page
Loading...
Need help?
General
