EasyManua.ls Logo

Ier 400 User Manual

Default Icon
4 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
IER 400
N0C4SEA2
USER SAFETY GUIDE
WARNING
THIS PRODUCT COMES WITH A LITHIUM BATTERY. BATTERY REPLACEMENT MUST IMPERATIVELY
BE PERFORMED BY QUALIFIED MAINTENANCE PERSONNEL. MOREOVER, ONLY IER APPROVED
MODELS MAY BE USED.
DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY REPLACED. REPLACE ONLY WITH THE
SAME OR EQUIVALENT TYPE RECOMMENDED BY THE MANUFACTURER. DISPOSE OF USED
BATTERIES ACCORDING TO THE MANUFACTURER’S INSTRUCTIONS.
DO NOT OPEN THE POWER SUPPLY UNIT CASE FOR ANY REASON, SINCE HIGH VOLTAGE MAY BE
PRESENT.
DO NOT REPLACE THE FUSE OF THE POWER SUPPLY UNIT.
The United States Federal Communications Commission (in 47 CFR 15.105) has specified that the following
notice be brought to the attention of users of this product.
NOTE
: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
In accordance with FCC requirements, changes or modifications not expressly approved by IER
could void the user's authority to operate this product.
Use of a shielded cable is required to comply within Class B limits of Part 15 of FCC Rules.
NORWAY
: This product is also designed for IT power distribution system with phase-to-phase
voltage 230V.
NORWAY & SWEDEN
: Apparaten skall anslutas till jordat uttag när den ansluts till ett nätverk.
THIS APPLIANCE MUST BE GROUNDED.
THIS PRODUCT MUST EXCLUSIVELY BE CONNECTED TO AN ELECTRICAL CIRCUIT THAT IS
- PROVIDED WITH A GROUND FAULT CIRCUIT INTERRUPTER (GFCI) COMPLYING WITH
IEC 364 AND NFC15-100 REGULATIONS, AND
- CONFORMING WITH THE VOLTAGE CHARACTERISTICS SPECIFIED BY THE NF EN 50160 STANDARD.
The cover(s), and/or door(s) of this product is (are) intended for occasional use and must be normally closed.
In compliance with the European Directive 2002/96/CE relative to the management of Waste Electrical and
Electronic Equipment (WEEE) implemented as of August 13, 2005, this product may not be disposed of with
regular household waste. All products concerned by this directive are marked with the above symbol.
The end owner of this product is responsible for either:
Transferring the product to an authorized treatment facility where the product components, recognized to
present a hazard to the environment and/or public health, will be recycled and recovered properly, or
Consulting with the manufacturer for appropriate product waste management according to the terms of the
manufacturer.
The information and specifications contained in this document are subject to change without prior notice.
ENGLISH
Question and Answer IconNeed help?

Do you have a question about the Ier 400 and is the answer not in the manual?

Ier 400 Specifications

General IconGeneral
BrandIer
Model400
CategoryPrinter
LanguageEnglish

Summary

General Safety Warnings

Battery Replacement Safety

Mandates replacement by qualified personnel using only approved models and types.

Power Supply Unit Precautions

Warns against opening the power supply case or replacing fuses due to high voltage.

Regulatory and Compliance Information

FCC Compliance Statement

States the equipment complies with FCC Part 15 limits for Class B digital devices.

Norwegian and Swedish Regulations

Notes design for specific Norwegian power systems and grounding requirement.

Grounding and Circuit Protection

Requires the appliance to be grounded and connected to a GFCI-protected circuit.

WEEE Environmental Compliance

Advises on proper disposal of electronic equipment according to the WEEE directive.

Operating Conditions and Electrical Characteristics

Environmental Conditions

Specifies operating temperature, storage temperature, and humidity ranges.

Power Requirements

Details authorized line voltage, frequency, and current ratings for operation.

Device Operation Procedures

Connecting and Powering Up

Instructions for connecting the AC power cord and powering on the device.

Powering Down and Electrical Safety

Guidance on powering off and disconnecting the unit to ensure electrical safety.

Accessing Further Documentation

Directs users to the website for installation and user documentation.

Related product manuals