Ier Automatic Systems PNG3 Series

Need help?

Do you have a question about the Ier Automatic Systems PNG3 Series and is the answer not in the manual?

Summary

1. IMPORTANT INFORMATION

1.3 Required Cables or Conduits

Specifies the necessary electrical cables and conduits, including power and control types, required for PNG installation.

1.4 U.L. (Underwriters Laboratories) Notes

1.7 Emergency Opening

Describes methods for emergency door opening, power shutdown, and electronic input configurations for safety compliance.

2. INSTALLATION

2.1 Move and Unpack Equipment

2.3 Preliminary Site Work

2.4 Installing the Unit

Guides on placing PNG units on baseplates, ensuring levelness, and securing them firmly to the floor.

2.5 Electrical Connections

Covers power requirements, customer terminations (L, N, GND, SHD), and essential wiring practices for PNG units.

2.6 Installation Wiring

Provides detailed wiring instructions for Master, Intermediate, and Slave units, including power and interconnect cables.

2.7 AS1007 Board (Interface)

3. START-UP

3.1 Final Adjustments

Covers crucial final adjustments, including photocell calibration and limit switch settings for optimal operation.

3.2 Check List

3.3 Troubleshooting

Provides guidance on diagnosing and resolving common issues like miswiring, motor direction, photocell alignment, and door operation.