18
FAULT DIAGNOSIS
WHY DOES IT HAPPEN ?
WATER DOES NOT ENTER MACHINE/DETERGENT NOT BEING
FLUSHED INTO DRUM.
q Check water supply
q Porthole door not firmly closed
q Water tap not turned on
q Bent inlet hose
q Sieve on inlet valve clogged
SUDS ESCAPING FROM DETERGENT DISPENSER TRAY.
q Detergent used is not a washing machine detergent
q Excessive detergent used
WATER LEAKAGE FROM THE MACHINE.
q Inlet / Outlet hose connection loose
q Fluff Filter not screwed on properly
q Inlet hose leaking
q Drain plug not fixed properly onto Drain hose.
MACHINE DOES NOT DRAIN.
q Fluff Filter clogged
q Outlet hose end above 1 meter from floor level
MACHINE VIBRATES STRONGLY DURING SPINNING.
q Machine not levelled properly
q Clothes not loaded as instructed
q water not drained completely
MACHINE DOES NOT START.
q Check position of programme selector knob
q Check water supply
q Porthole door not closed properly
MOTOR NOISE.
q It is normal for noises to be heard while motor is running. However
wash load, belt tension and motor mounting bolt should be
checked for specified limits.
PUMP NOISE.
q It is normal for noises to be heard from the pump during the start-
up and final stage of draining. However check for fluff filter
clogging.
FAULT DIAGNOSIS
WHY DOES IT HAPPEN ?
WATER DOES NOT ENTER MACHINE/DETERGENT NOT BEING
FLUSHED INTO DRUM.
SUDS ESCAPING FROM DETERGENT DISPENSER TRAY.
WATER LEAKAGE FROM THE MACHINE.
MACHINE DOES NOT DRAIN.
MACHINE VIBRATES STRONGLY DURING SPINNING.
MACHINE DOES NOT START.
MOTOR NOISE.
PUMP NOISE.
To Next Page
Loading...
