19
SAFETY PRECAUTIONS
1. Ensure that the machine is properly balanced on four adjustable feet.
2. Ensure that the machine is connected to 3 pin socket with earth and
16 amps fuse.
3. The machine is tested with water during assembly for performance
checking. Condensed droplets of water may remain inside the
0
drum. It is advisable to run the machine without wash load at 50 C
with detergent for the first time after installation.
4. The programme knob should be turned clockwise only.
5. Programme selection must be done prior to switching on the
machine. For resetting of programme, switch off the machine, select
the programme and re-start. Do not operate the machine beyond the
printed zone.
6. Servicing should be handled by the Company’s authorized
personnel only.
7. Check for the end of the programme before opening porthole door.
The door can be opened about 90 seconds after the wash cycle is
over or machine is switched off. This is a safety feature. The door
should not be forced open.
8. Check label on garments for determining conditions under which
fabrics are to be washed.
9. Use detergent recommended for washing machine.
10. Ensure that the electrical line on which the machine is used can take
the required load.
11. Check the inside of drum before loading the clothes.
12. Protect the machine from direct sunlight and do not splash water on
it. Clean with a damp cloth.
13. Keep your machine dry to avoid corrosion / rusting. Take special
care to wipe the machine after cleaning fluff filter.
14. The machine should ideally be installed on the floor, it can be
installed on any suitable platform or trolley, if desired by the
customer.
15. Clean the shell lower and detergent tray periodically by taking out
the detergent tray.
16. Incase of plastic tabletop do not use the tabletop as an ironing
board or for placing heavy items.
SAFETY PRECAUTIONS
To Next Page
Loading...
