PROGRAMME RUN
Note:
q During the programme run the knob turns automatically in the clockwise
direction only.
q Washing, rinsing and spinning can be seen through the porthole window.
q At any moment the position of the knob with respect to its start position
shows how far the programme has advanced.
q The starting point is just beyond the thick line on the knob.
SWITCHING OFF THE MACHINE
q The wash ends automatically at the end of each programme at the thick line
on the knob.
q To switch the machine OFF turn the ON / OFF switch to ‘O’ position
q The indicator lamp goes off.
q Porthole door can be opened only after 90 seconds
q Remove clothes from inside the machine
q Leave door slightly ajar to dry out the inside of the machine
CHECK POINTS
Before switching your machine ‘ON’ check...
q The machine is connected to a 220V, 50 Hz supply with proper earthing.
q The water inlet stopcock is fully open.
q The hoses are not bent or twisted.
q Dry clothes are loaded into the machine drum, and door is closed firmly
with a click.
q The required amount of detergent and fabric conditioner is filled in their
respective compartments.
q The Water Plus Button is pressed, if required.
q The spin speed selector button is pressed if 600 r.p.m. spin is required.
q The programme Selector knob is turned to the appropriate programme
position in a clockwise direction only.
q The Fluff Filter/drain hose is not open.
18
To Next Page
Loading...
