STAGE IV : Spin Drying: - Long Spin
q Spin drying takes place at 700 r.p.m. and then goes upto 1100 r.p.m.
q Any spin speed between 400 rpm min. to 1100 rpm. Max. can be
selected using spin speed selector knob.
q After spinning, the clothes tumble for 6 Minutes to reduce creasing.
2. Easy Care Programme (Synthetics / Polyster)
q For polyester blended fabrics like terrycots etc.
STAGE I : Pre-Wash:
q The cycle takes place before the main wash.
q To be used for heavily soiled delicate clothes.
q At the end of the pre-wash the dirty water is pumped out automatically.
q IN CASE CLOTHES ARE NOT HEAVILY SOILED, THE PRE-WASH CAN
BE AVOIDED BY SETTING THE PROGRAMME SELECTOR KNOB TO
ANY OF THE MAIN WASH PROGRAMMES AS GIVEN BELOW
STAGE II: Main Wash : NORMAL / DELICATES
q If clothes are very lightly soiled, set the programme selector knob at
‘DELICATES’to reduce washing time and energy consumption.
q Clothes are soaked for 12 Minutes if soak button is pressed.
q Main wash is completed with intermittent short spins of 700 rpm max.
STAGE III: Rinse
q After washing, the rinsing is done automatically. In this programme your
clothes are rinsed three times.
q For most efficient rinsing intermittent short spins are provided in the
rinse programme at 700 rpm max.
q Fabric conditioner is drawn from the detergent dispenser tray marked
(middle chamber) during the last rinse (Additives). If no conditioner
is added, the machine continues to rinse in ordinary water.
q If rinse hold button is pressed, the clothes will remain Floating in water
during last rinse till the button is pressed again in order to continue the
further programme.
STAGE IV: Spin Drying : Short Spin
q Spin speed selector knob to be used for spinning in the range of 400 to
700 rpm.
q Spinning is followed by Anticrease cycle of 3 minutes tumble, during
which the clothes are loosened for the convenience of open drying
without creasing.
13
To Next Page
Loading...
