PROGRAMME RUN
Note:
q During the programme run the knob turns automatically in the clockwise
direction only. Manual setting/advancement should not be done during
programme run.
q Washing, Soaking Rinsing and Spinning can be seen through the porthole
door.
q At any moment the position of the knob with respect to its start position
shows how far the programme has advanced.
q The starting point is just beyond the thick line on the Facia.
SWITCHING OFF THE MACHINE
q The wash ends automatically at the end of each programme at the thick line.
q To switch the machine OFF release the START button.
q The indicator lamp goes off.
q Porthole door can be opened after 90 seconds of switching off the machine.
q Remove clothes from inside the machine
q Leave door slightly ajar to dry out the inside of the machine.
CHECK POINTS
Before switching your machine ‘ON’ check...
q The machine is plugged in and switched on to a 220V, 50 Hz supply with
proper earthing.
q The water inlet stopcock is fully open.
q The hoses are not bent or twisted.
q Dry clothes are loaded into the machine drum, and door is closed firmly
with a ‘click’.
q The required amounts of detergents and fabric conditioner are filled in their
respective compartments.
q The Water Save Device Button, Rinse Hold Button, soak button, Eco button,
is pressed if required.
q The spin speed selector knob is turned to Appropriate position.
q The programme Selector knob is turned to the appropriate programme
position in a clockwise direction only. This is very important.
q The Coin Trap/ drain hose is not open.
q Start Button is pressed.
21
To Next Page
Loading...
