MOTOR NOISE
It is normal for noises to be heard while motor is running. However wash
load, belt tension and motor mounting bolt should be checked for specified
limits.
PUMP NOISE
It is normal for noises to be heard from the pump during the start-up and
final stage of draining.
SAFETY PRECAUTIONS
1. Ensure that the machine is properly balanced on four adjustable feet.
2. Ensure that the machine is connected to 3 pin socket with earth and 16
amps fuse.
3. The machine is tested with water during assembly for performance
checking. Condensed droplets of water may remain inside the drum. It is
0
advisable to run the machine without wash load at 60 C with detergent
for the first time after installation.
4. The programme knob should be turned clockwise only.
5. Programme selection must be done prior to switching on the machine. For
resetting of programme, switch off the machine,select the programme and
re-start. The programmer knob should not be Advanced Ahead Manually
once the programme is selected & Running, as it may affect the
performance of the machine due to excessive vibrations.
6. Press the START button to switch on the machine and release it to switch it
off.
7. Servicing should be handled by the Company’s authorized personnel
only.
8. The door can be opened only after 90 seconds when the wash cycle is
over or machine is switched off. This is a safety feature. The door
should not be forced open.
9. Check label on garments for determining conditions under which fabrics
are to be washed.
10. Use detergent recommended for washing machine.
11. Ensure that the electrical line on which the machine is used can take the
required load.
12. Check the inside of drum before loading the clothes.
13. Protect the machine from direct sunlight and do not splash water on
it. Clean with a damp cloth.
14. Keep your machine dry to avoid corrosion / rusting. Take special care to
wipe the machine after cleaning the coin trap.
25
To Next Page
Loading...
