15. The machine should be ideally installed on the floor. It can be installed on
any suitable platform or trolley, if desired by the customer.
16. Clean the shell lower and detergent tray periodically by taking out the
detergent tray.
17. Prolonged use of water carrying impurities, salts etc. may result in scale
formation on the surfaces of the components that are exposed to water.
Periodical descaling using approved descaling agent is advisable for longer
life of the components.
SPECIAL NOTE
ONLY USE A DETERGENT RECOMMENDED FOR FRONT LOADING WASHING
MACHINES. A DETERGENT WHICH FOAMS EXCESSIVELY CAN DAMAGE THE
MOTOR AND DETERIORATE THE RINSE QUALITY.
INSTALL MACHINE IN A ROOM WITH ADEQUATE VENTILATION.AVOID A
ROOM WITH NO WINDOWS. THE BACK OF THE MACHINE SHOULD BE AT
LEAST 4 INCHES (100 mm )AWAY FROM THE WALL.
IF YOU USE A COVER OR TABLE CLOTH ON THE TOP LID, MAKE SURE
THAT THE VENTILATION SLOTS AT THE BACK ARE NOT COVERED OR
BLOCKED. THIS PRECAUTION WILL PROLONG THE LIFE OF
ELECTRICAL AND RUBBER COMPONENTS.
26
To Next Page
Loading...
