ifi NEO STREAM - DC Power Supply Connection; M12 Ethernet Input; RJ45 Ethernet Input

7
4. Menu/Output Selector
Short press: Displays the current digital lter set. To change the digital lter, press the knob to enable
selection, turn to change the lter, and press the knob again to conrm. Please see item 2, VIII.
Long press: Displays the output setting. Choose between Analogue, Digital, or USB DAC audio
(if connected) by turning the knob, and press the knob again to conrm.
5.
Power Switch And Indicator
Short press to switch on, long press ≥ 2s to switch o.
6.
USB-C Input/Output
a) Output - Connect to USB DAC
b) Input - Connect to HDD, USB DISK etc.
Tip: The USB-C connector has Active Noise Cancellation (ANC) technology built-in.
7. DC Power Supply Connection
DC 9V/2.0A, 12V/1.8A, 15V/1.2A* power input. Please connect NEO Stream to the enclosed power supply.
8. M12 Ethernet Input
Connect a network cable with an M12 X-code 8-pin connector.
9. RJ45 Ethernet Input
Connect a wired network cable with a RJ45 connector.
*A power supply unit must be able to deliver minimum rated repetitive current.