Iflight SucceX-Force 5.8GHz

To Next Page

SucceX-Force 5.8GHz

25mW/100mW/400mW/800mW

CH ANN EL B AN D PO WER

Video Out

(7V~36V)

Ground (GND)

5V camera output

5V Output only for FPV cameras!

The RX wire can be linked to any free UART TX on your Flight Control

and setup for IRC Tramp VTX telemetry to change parameters of

your VTX through your OSD.

If you experience severe signal interference in your video feed please

inspect your power source for electrical noise. Some common issues

are too long motor screws, no additional capacitor added to your ESC,

bad or noisy motors, bad or noisy ESC.

Wiring Diagram

Need help?

Do you have a question about the Iflight SucceX-Force 5.8GHz and is the answer not in the manual?

Summary

Ensures correct 5V output usage exclusively for FPV cameras to prevent damage or malfunction.

Connects RX wire to Flight Control UART TX for VTX parameter changes via OSD using IRC Tramp.

Addresses severe signal interference by inspecting power source issues like long motor screws or noisy ESCs.

Details how to enter and perform band selection using long presses of the Channel/Band button.

Explains the short press method for selecting FPV video channels, indicated by LED flashes.

Guides users on selecting the video transmitter power level (25mW-800mW) via button presses.

General