IGEL Technology GmbH Hardware Manual IGEL UD2 / IZ2
4/11 Version 1.0
– February, 2018
•
Gloss warning for devices without display: This device is not intended for use in the direct
field of view at visual display workplaces. To avoid incommoding reflexions at visual display
workplaces this device must not be placed in direct field of view.
•
Lithium battery caution:
o The Lithium battery (button cell) installed in the device may only be replaced by
authorised, specially trained personnel.
o Contact your supplier or the manufacturer for servicing and repairs.
o Danger of explosion if battery is incorrectly replaced.
o Dispose of used batteries according to the manufacturer’s instructions.
•
Excessive sound pressure from ear-/headphones can cause hearing damage/hearing loss.
Adjustment of the volume control as well as the equalizer to other settings than the centre
position may increase the ear-/headphones output voltage and therefore the sound pressure
level. The use of factors influencing the ear-/headphones output other than those specified
by the manufacturer (e.g. operating system, equalizer software, firmware, driver) may
increase the ear-/headphones output voltage and therefore the sound pressure level.
•
UL 62368: This equipment must be grounded. The power cord for the equipment must only
be connected to socket-outlets providing earthing connection.
•
Visit www.igel.com for the latest product information and safety instructions updates.
•
Specific Safety Instructions for UD9:
o To avoid damage or malfunction, do not use hard or abrasive objects for touching the
LCD module.
o Do not exert pressure on the LCD module.
o Use a soft dry cloth without chemicals for cleaning, because the surface of polarizer is
very soft and easily scratched.
o It is dangerous that moisture come into or contacted the LCD module, because moisture
may damage LCD module when it is operating.
o If the liquid crystal material leaks from the panel, it should be kept away from the eyes or
mouth. In case of contact with hands, skin or clothes, it has to be washed away
thoroughly with soap.
o When fixed patterns are displayed for a long time, remnant image is likely to occur.
o Do not leave the LCD module facing the sun.
Visit edocs.igel.com
for more information.
To Next Page
Loading...
Need help?
General
