iGenix IG8127 - Hints for Great Tasting Coffee; Fuse Replacement

6
DESCALING YOUR APPLIANCE
Tokeepyourcoffeemakeroperatingefciently,periodicallyyoushouldcleanawaythelimescaleleftby
the water according to the water quality in your area and the frequency of use. We recommend descaling
your appliance as follows, using a solution of white vinegar and cold water. A solution of two tablespoons
(30ml) white vinegar in one carafe of cold water works best.
• Fill the tank with the vinegar solution to the maximum level as indicated on water gauge.
• Insert glass carafe onto the warming plate.
• Ensurethatthepaperlter(withoutgroundcoffee)andfunnelareassembledinplace.
• Switch on the appliance and allow it to “brew” de-scaling solution.
• After “brewing” one cup of the solution, turn off the appliance.
• Leave the solution for 15 minutes and repeat step 3-5, until the water tank is completely empty.
• Rinse by operating the appliance with water at least 3 times.
HINTS FOR GREAT-TASTING COFFEE
• A clean coffee maker is essential for making great-tasting coffee. Regularly clean the coffee maker as
 speciedinthe“CLEANINGANDMAINTENANCE”section.Alwaysusefresh,coldwaterinthe
coffee maker.
• Store unused ground coffee in a cool, dry place. After opening a package of ground coffee, reseal it
tightly and store it in a refrigerator to maintain its freshness.
• Foranoptimumcoffeetaste,buywholecoffeebeansandnelygrindthemjustbeforebrewing.
• Donotreusegroundcoffeeasthiswillgreatlyreducethecoffee’avour.Reheatingcoffeeisnot
 recommendedascoffeeisatitspeakavourimmediatelyafterbrewing.
• Clean the coffee maker when over-extraction causes oiliness. Small oil droplets on the surface of
brewed, black coffee are due to the extraction of oil from the ground coffee.
• Oiliness may occur more frequently if heavily roasted coffees are used.
Fuse Replacement (Class I)
This appliance must be earthed. Remove the central screw on the plug and
open the shell. Take out the fuse and replace with a new fuse of the same Amp.
Install the shell again and tighten the screws.
MAINS PLUG FUSE REPLACEMENT