• Clean and dry the cooling device.
• Leave the lid open to prevent mold developing within the cooling device.
NOTICE! Damage hazard
Check that the voltage specification on the data plate corresponds to that of the energy
supply.
Only connect the cooling device as follows:
• With the DC connection cable to a DC power supply in the vehicle
• With the AC connection cable to an AC power supply
Never pull the plug out of the socket by the cable.
If the cooling device is connected to a DC outlet, disconnect the cooling device and other
power consuming devices from the battery before connecting a quick charging device.
If the cooling device is connected to a DC outlet, disconnect the cooling device or switch
it off when turning off the engine. Otherwise the battery may be discharged.
The cooling device is not suitable for transporting caustic materials or materials contain-
ing solvents.
The insulation of the cooling device contains flammable cyclopentane and requires spe-
cial disposal procedures. Deliver the cooling device at the end of its life-cycle to an ap-
propriate recycling center.
Do not place the cooling device near open flames or other heat sources (heaters, direct
sunlight, gas ovens, etc.).
Risk of overheating! Ensure at all times that there is a minimum of 50 mm mm ventilation
on all sides of the cooling device. Keep the ventilation area free of any objects that could
obstruct the air flow to the cooling components. Do not use or store the cooling device in
closed compartments or areas with none or minimal air flow.
Do not fill the inner container with ice or fluids.
Never immerse the cooling device inwater.
Protect the cooling device and cables against heat and moisture.
The cooling device shall not to be exposed to rain.
5
To Next Page
Loading...
