ICF18, ICF32, ICF40, ICF60, ICF80DZ Safety instructions
9
A
I
2Safety instructions
D
DANGER! Failure to obey these warnings will result in death or
serious injury.
Electrocution hazard
• On boats: If the device is powered by the mains, ensure that the
power supply has a residual current device (RCD), a residual cur-
rent circuit breaker (RCCB), or a ground fault circuit interrupter
(GFCI). Installation, especially in potentially damp areas, must be
in accordance with all applicable installation regulations.
• Do not touch exposed cables with your bare hands. This applies
especially when operating the device from the AC mains.
• Before starting the device, ensure that the power supply line and
the plug are dry.
!
WARNING! Failure to obey these warnings could result in death
or serious injury.
Electrocution hazard
• Do not operate the cooling device if it is visibly damaged.
• If the cooling device's power cable is damaged, it must be
replaced with a suitable power cable or assembly available from
the manufacturer or its service agent to prevent safety hazard.
• This cooling device may only be repaired by qualified personnel.
Improper repairs can lead to considerable hazards.
• Plug the device to sockets that ensure proper connection espe-
cially when the device needs to be earthed.
Fire hazard
• When positioning the device, ensure the supply cord is not
trapped or damaged.
NOTICE!
Indicates a situation that, if not avoided, can result in property
damage.
NOTE
Supplementary information for operating the product.
Igloo ICF18, ICF32, ICF40, ICF60, ICF80DZ_OPM_4445104001_APAC_en_202x-xx-xx.book Page 9 Thursday, September 28, 2023 6:55 PM
To Next Page
Loading...
