Igloohome Mortise 2+ - Airbnb Connect; Airbnb Connect Setup

31
Airbnb Connect
Airbnb Connect automates the generation of PIN codes for your Airbnb guests based on
their approved reservations. It costs USD$4.99 per month, but is currently on free trial.
Here are the steps to activate Airbnb Connect
Step 1: Connect to your Airbnb
Under [Account Settings], select [Connect with Airbnb], then click [OK].
Step 2: Connect to Airbnb listings
Under [Reservations], click the [Add] icon to select a home to connect to.
Select Airbnb Listing and PIN Time to associate.
Note:
• Emails with PIN code will be sent to the guest between 1 to 48 hours before
check-in time (configurable).
• PINs will only be valid between the check-in and check-out times.
Step 3: Change Check-in and Check-out time
Under [Configuration], select [Manage Properties] followed by the listing to view or edit its
details.
Notes:
• If the access mail has not been sent, changing your check-in/check-out time via the app
modifies the start and end time of the PIN codes to be shared with your guest.
• If the access mail has been sent, changing these details will only aect the next
reservation.
• Changing these details on the igloohome app does not update the check-in/check-out
time on the listing on the Airbnb website.
2
Disconnect Airbnb
Should you prefer to generate PIN codes for your guests manually, you may disconnect your
Airbnb listing from the igloohome home listing with the steps below.
1. Under [Reservations], disconnect all the listings (if any).
2. Under [Account Settings], select [Disconnect with Airbnb].
Should you wish to completely disconnect your Airbnb account from your igloohome account,
make sure that all your Airbnb listings have been disconnected in the above step, then go to:
Airbnb Host Website > Connected Apps > Select igloohome to disconnect
Airbnb Connect
8
7