Need help?Do you have a question about the IGM FD300 and is the answer not in the manual?
Details the standard components and specifications for both FD300 and FD600 models.
Instructions for assembling basic components like screws, nuts, and knobs according to Illustration B1.
Attaching edge guides for the FD300 model to the jig.
Fitting sliding stops, U-brackets, and edge stops for the FD600 model as per Illustrations B2-B3.
Attaching brackets #13 to the template using screws #14 as shown in Illustration B4.
Assembling clamping bars #4 with springs #9 and washers #8 as per Illustration B5.
Details for cutting standard 12.7mm (1/2") half blind dovetail joints using the template.
Details for cutting standard 12.7mm (1/2") rebated half blind dovetail joints.
To Next Page
General