Ignis AWF 591 - User Manual

Questions and Answers

M
Monica HopkinsAug 9, 2025
What to do if my Ignis Washer won't start and no lights are on?
- A
  Andrea HuntAug 9, 2025
  If your Ignis Washer isn't starting and no lights are illuminated, try these steps: First, ensure the door is closed properly and press the “Start/Pause” button again. Then, check if the mains plug is securely inserted into the socket and verify that the wall socket is functioning correctly by testing it with another device like a table lamp. Also, make sure the siphon is correctly installed and clean. Finally, check that sufficient water is entering the machine and that the mesh filters in the water connection are not blocked.
K
Kevin BarronAug 14, 2025
Why is my Ignis AWF 591 vibrating so much during the spin cycle?
- G
  George TurnerAug 14, 2025
  If your Ignis Washer is vibrating excessively during the spin cycle, ensure that the washing machine is level and standing firmly on all four feet. Also, confirm that the transport bolts have been removed.
S
Susan BakerAug 25, 2025
What to do if my Ignis AWF 591 Washer has poor final spin results?
- J
  Jeremiah WilliamsAug 25, 2025
  If your Ignis Washer's final spin results are poor, and the laundry is still too wet, try adding other articles of laundry and repeating the spin cycle. Make sure you are using the correct detergent dosage. Also, verify that spin speed “0” was not selected.
T
Timothy AguilarAug 29, 2025
How to fix a draining fault in my Ignis Washer?
- J
  Jamie BergerAug 29, 2025
  To address a draining fault in your Ignis Washer, first check the drain hose for any kinks. Then, inspect the pump and filter for any blockages. Finally, check if the water in the drain hose is frozen.
B
Brandi McgeeSep 3, 2025
What to do if my Ignis Washer shows Water Stop fault (if fitted)?
- C
  Carol HurstSep 3, 2025
  If your Ignis Washer shows a Water Stop fault, it could be due to excess foaming or a leak. If it's due to excess foaming, switch the appliance off, pull out the mains plug, and turn the water tap off. If it's due to a leak in the washing machine, carefully tilt the appliance forwards to allow the collected water to flow out from the bottom.
J
Jared FrostSep 10, 2025
What to do if there is a fault in the water supply in Ignis AWF 591?
- M
  Miguel WilliamsonSep 12, 2025
  If you're experiencing a water supply fault with your Ignis Washer, first check that the water tap is fully turned on and that the water supply pressure is sufficient. Also, check the water inlet hose for any kinks or blockages. Inspect the water connection mesh filters for blockages. Ensure that the water supply hose isn't frozen. Finally, check if the washing machine has a safety hose and the safety valve is open; if so, replace it with a new safety hose.