26
DRAINING RESIDUAL WATER
CARE AND MAINTENANCE
Appliance exterior and control panel
•
Can be washed down with a soft, damp cloth
•
A little neutral cleaner (not abrasive) can be used
if necessary
•
Dry with a soft cloth
Door seal
•
Rub down occasionally with a damp cloth
•
Regularly check the seal folds for foreign bodies
Filter
•
We recommend that you check and clean the
filter regularly, at least two or three times a year
or (see “Removing the Filter”)
When should the residual water be removed?
•
To transport the machine (relocation)
•
In a frost-endangered room. In this case, it is
recommended that the machine be emptied after each
wash cycle.
Before emptying the residual water, switch the
appliance off and unplug it from the mains socket.
The residual water drain hose is located behind the
plinth.
1.
Remove the plinth cover.
2.
Grasp the cap and pull out together with the hose.
Place a low container beneath it. Pull off cap from end
of hose.
3.
Drain the water into a low container until no more
water flows out. Then close the residual water drain
hose and insert it again.
Before using the washing machine again:
1.
Pour approx. 1 litre of water into the detergent drawer
to reactivate the Eco system.
2.
Reinsert the plug in the socket.
50110087GB.fm Page 26 Thursday, March 2, 2006 4:37 PM
Black process 45.0° 100.0 LPI
To Next Page
Loading...
