IgniteNet Spark N300 - User Manual

– 1 –
Quick Start Guide
Cloud-Enabled Enterprise Access Point
Spark™ AC750 and Spark™ N300
The Spark AC750 and Spark N300 are dual- and single-band enterprise access
points (APs). The units are designed to be operated either placed on a desk or
mounted on a wall or ceiling. The package includes a mounting plate for attaching
the AP to a wall or ceiling T-bar. The APs can be powered either by the universal
power supply included in the package, through an Ethernet cable connection from
a Power-over-Ethernet (PoE) injector, or from a 802.3af-compliant PoE switch.
The Cloud-Enabled Enterprise Access Point includes these models:
◆ SP-AC750 — dual-band concurrent enterprise AP with integrated antennas
plus passive Power-over-Ethernet (PoE)
◆ SP-AC750-3AF — dual-band concurrent enterprise AP with integrated
antennas plus 802.3af Power-over-Ethernet (PoE)
◆ SP-N300 — single-band enterprise AP with integrated antennas plus passive
Power-over-Ethernet (PoE)
◆ SP-N300-3AF — single-band enterprise AP with integrated antennas plus
802.3af Power-over-Ethernet (PoE)
Note: For Safety and Regulatory information, refer to the Safety and Regulatory
Information document included with the AP.
www.ignitenet.com

Summary

Installation - Getting Started

Installation Precautions and Safety

Advises professional installation and compliance with local radio regulations.

Installation - Wall Mounting

Wall Mounting Steps

Installation - Ceiling Mounting

Suspended Ceiling Mounting Steps

Connecting and Powering the AP

Connecting Network Cables

Instructions for connecting Ethernet cables to WAN/PoE and LAN ports.

Powering the AP

Describes powering via AC/DC adapter or PoE injector/switch.

AP Operation and Web Interface Access

Verifying AP Operation via LEDs

Accessing the Web Management Interface

Steps to connect a PC and access the AP's web UI for configuration.

AP Configuration and Management

Completing the Setup Wizard

Initial configuration steps including country selection and management mode choice.

Cloud Management Setup

Stand-Alone Management Setup

IgniteNet Spark N300 Specifications

General

Model	Spark N300
Wireless Standard	802.11b/g/n
Frequency Band	2.4 GHz
Maximum Data Rate	300 Mbps
Ethernet Ports	1 x 10/100 Mbps
Antenna Type	Internal
Antenna Count	2
Power over Ethernet (PoE)	Yes (802.3af)
Mounting Options	Wall or Ceiling
Operating Temperature	0°C to 40°C
Power Supply	12V DC